Quality Control Inspector
Posted: 4/3/2018 8:53:40 AM
This job is closed
NDT.org Job Number:
63482
* Please reference NDT.org Job Number on all correspondence
Contact:
Jerry Bryant
Phone:
704-361-0777
Fax:
803-619-1095
Company:
C. M. Steel
State:
SC South Carolina
Contact:
Jerry Bryant
Country:
United States
Length:
Full Time - Permanent
Pay:
DOE
Email:
jbryant@cm-steel.com
Essential Job Functions
1. Must understand: SMAW, FCAW, GMAW.
2. Involved in design (preparation of plans and drawings for weldments) and examination (detection and measurement of weld discontinuities and verification of fabrication requirements).
3. Assure that all fabrication and welding is performed in accordance with applicable codes and standards.
4. Inspect welds and record the type of inspection and piece marking of piece inspected.
5. Assist in sequencing of welds and/or heat to minimize distortion.
6. Monitor processes to assure that written procedures are followed.
7. This person shall have the authority to stop work on any project where quality is questionable.
8. Perform other duties as required by management.
Qualifications and requirements
Preferred: Two or more years experience in all aspects of manufacturing in the steel fabrication industry.
1. Must understand: SMAW, FCAW, GMAW.
2. Involved in design (preparation of plans and drawings for weldments) and examination (detection and measurement of weld discontinuities and verification of fabrication requirements).
3. Assure that all fabrication and welding is performed in accordance with applicable codes and standards.
4. Inspect welds and record the type of inspection and piece marking of piece inspected.
5. Assist in sequencing of welds and/or heat to minimize distortion.
6. Monitor processes to assure that written procedures are followed.
7. This person shall have the authority to stop work on any project where quality is questionable.
8. Perform other duties as required by management.
Qualifications and requirements
Preferred: Two or more years experience in all aspects of manufacturing in the steel fabrication industry.
Skills:
Skills:
Quality Control Inspectors with AWS CWI certification and experience in structural steel fabrication are needed for 1st & 2nd shift operations.
Quality Control Inspectors with current or previous certification and experience as NDE Level II in UT or MT are preferred.
Quality Control Inspectors with AWS CWI certification and experience in structural steel fabrication are needed for 1st & 2nd shift operations.
Quality Control Inspectors with current or previous certification and experience as NDE Level II in UT or MT are preferred.
