SensorScan for Sensor Networks Inc
Instrument & Control Engineer
This job is closed Job Number: 7609 * Please reference Job Number on all correspondence
Contact: Arun
Phone: +971-2-6422262
Fax: +971-2-6422133
Company: Oceaneering OiS
State: AbuDhabi
Contact: Arun
Country: UAE
Length: 1 Year ( Extendable )
This is a 1 year ( extendable ) contract opening based at AbuDhabi, UAE. The job is based onshore and the work is for 8 Hrs / day and 5 days / week.

Principal accountabilities include:

Preparation & review of project specific documents for the supervisory control system ( SCS ) including but not limited to:

Design specifications, philosophy documents, cause & effect charts, functional design specifications, logic block diagrams, logic sequence diagrams, instruments indices, instrument data sheets, wiring diagrams & schematics, sizing calculations, equipment layouts, loop diagrams, safety studies, reliability mode analysis & QRAs etc.

Standard engineering & detailed design procedure, design change control procedure, QA & inspection procedure, site installation procedure, safety procedure, hot cutover procedure, power-up and commissioning procedures, handover procedures, troubleshooting procedures, operating & maintenance procedures.

Participation in design review meetings & intermediate stage inspection visits.

Participation in factory acceptance tests & site acceptance tests

Participation in site preparation and supervision of, installation, power-up , hot-cutover and commissioning activities for the various systems & field devices.

Liaison with independent third party design verification agency

Liaison with site and other company departments as required

Clearance of punch list & warranty related issues

Preparation of close-out reports highlighting areas of concern and lessons learnt.

Degree in Engineering
Minimum 15 years direct experience in instrumentation & control
At least 8 10 years experience in major projects related to DCS, PLC & SCADA systems in offshore Oil & Gas company environment at a senior level.
Knowledge of international standards such as IEC or ISA, specifically IEC 61508
Knowledge of and experience with hot cutovers, integration of DCS/ PLC. Real time databases, data highways, open systems, time synchronization in networks.
Proficiency in Microsoft Office & good command of the English Language