Acuren Inspection is looking for a qualified CWI Inspector with supporting NDT certifications to support our operations in Savannah, GA. Successful candidates must be able to travel up to 75% throughout GA, SC, AL, and FL. The CWI will perform inspections or to verify that the work inspected, and records maintained, conform to the requirements of the applicable standards. This individual will have responsibility for determining if welded assemblies conform to workmanship and acceptance criteria.

Responsibilities
Verify that the welding equipment to be used for the work is appropriate for the use with the welding procedure and has the capability to meet the applicable requirements of the welding procedure.
Verify that the welding procedures are as specified and are qualified, and that the welding performed is performed in conformance to the applicable procedure.
Submit to client technically accurate reports documenting equipment condition
Provide client with technical recommendations for the repair, re-rate, replacement, and/or alteration of plant equipment, as required for safe operation within stated operating parameters for durations specified by client
Provide technical input to client as required for welding and metallurgical issues
Provide technical guidance, on a application of non-destructive examination techniques and procedures
Fully comply with all Acuren and client safe work practices and actively participate in all site safety initiatives